![]() but whats unique about it- it also can take a 4pin fan connector (from MB) as INPUT, and then adjust fans connected to IT (the noctura) based upon the speeds the MB is telling that fan header to spin at. it allows you to have a physical dial to set your 4-pin pwm fan's speed. This noctura fan controller is EXCELLENT. But since the BMC can be finicky, I didn't want to update without their blessing.įor those that DO want the normal SM IPMI fan curve, but simply want it at a REDUCED curve (ie you still want IPMI to gradually up/down the fan speeds based upon temperatures its reads) there is a hardware option. So technically if your board uses SMT_?, you should be able to use the higher version on this page. ![]() I've asked SMC support If I can use the latest on SMM or SMT for a specific board, they said they have to test in their lab on respective board before releasing it to public. As you can see there are two variants SMM & SMT for IPMI. If anyone needs it, search for SMM_X9 and grab the 2.74. I think I was having issue with IPMIView iKVM console and SMC suport provided the newer firmware. The listed version for this motherbord is 2.59. Interestingly same fans ran at a higher speed on X10DRI-T4+ board. ![]() Can't recall the SM part# just swapped out the housing. I have Nidec 0.3A fans and run about 2000 rpm. Just the Standard, Optimum, Heavy I/O and Full. ![]() None of the intermediate speed commands work on X9DRW-iF.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |